Table of Contents
Advertisement
•
Inspect the pilot burner to ensure it is clear of any
Lava rock.
•
The gas burns at the point of the least resistance. In
case of an uneven flame pattern it may be necessary to
adjust the materials in the pans (using an object such as
a screwdriver) to achieve the desired effect.
E. Install the Logs
WARNING
Fire Risk
Explosion Risk
Personal Injury Risk
Failure to position the parts in accordance
with the diagrams provided with the log
packages or failure to use only parts
approved with this appliance may result in
property damage or personal injury.
•
Install the logs using the installation instructions included
with them.
*
Discard the Ember screen supplied with the Real Wood
log set. This screen is for use on indoor log sets only.
•
Light the burner as outlined in the operating section. Allow
the flame pattern to stabilize. If you are satisfied with the
flame pattern go to the next step. If you want more or less
flame around the front log, turn off the gas and move the
grate backward or forward.
•
Once you are satisfied, turn on the gas and go on to the
next step.
•
Arrange the top logs as shown in your log set up
instructions. Light the burner as outlined in the operating
instructions and allow the flame to stabilize.
•
Spread additional lava rock around the outside of the
burner pan on the floor of the fireplace. If possible, cover
the gas connector with the cinders. DO NOT cover any
part of the pilot assembly.
10
• Outdoor Lifestyles by Hearth & Home Technologies Burner/Hearth Kits • 4004-315 Rev D • 5/2013
F. Adjust the Pilot Flame
The pilot flame should be a soft blue color and should sur-
round the last 1/2 in. of the thermocouple tip. The pilot ad-
justment screw is located on pilot valve beside control knob.
Refer to Figure 4.3. If pilot flame must be adjusted, use a
standard slotted screwdriver to turn screw clockwise to re-
duce flame or counterclockwise to increase flame.
Figure 4.3
Pilot Adjustment Screw
Pilot Adjustment Screw
Advertisement
Table of Contents
