Table of Contents
Advertisement
Quick Links
4X4 HDMI 1.3 over CAT5
Matrix Switch with IR Pass-Through
© 2009 Avenview Inc. All rights reserved.
The contents of this document are provided in connection with Avenview Inc. ("Avenview") products. Avenview makes no representations or warranties with
respect to the accuracy or completeness of the contents of this publication and reserves the right to make changes to specifications and product descriptions at any
time without notice. No license, whether express, implied, or otherwise, to any intellectual property rights is granted by this publication. Except as set forth in
Avenview Standard Terms and Conditions of Sale, Avenview assumes no liability whatsoever, and disclaims any express or implied warranty, relating to its products
including, but not limited to, the implied warranty of merchantability, fitness for a particular purpose, or infringement of any intellectual property right.
Reproduction of this manual, or parts thereof, in any form, without the express written permission of Avenview Inc. is strictly prohibited.
www.avenview.com
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Avenview SW-HDMI-C5-4X4
Summary of Contents for Avenview SW-HDMI-C5-4X4
- Page 1 No license, whether express, implied, or otherwise, to any intellectual property rights is granted by this publication. Except as set forth in Avenview Standard Terms and Conditions of Sale, Avenview assumes no liability whatsoever, and disclaims any express or implied warranty, relating to its products including, but not limited to, the implied warranty of merchantability, fitness for a particular purpose, or infringement of any intellectual property right.
-
Page 2: Table Of Contents
Introduction ........................... 4 Package Contents ........................6 Before Installation........................6 Panel Description ........................7 1.7.1 SW-HDMI-C5-4X4 Front Panel ....................7 1.7.2 SW-HDMI-C5-4X4 Rear Panel ....................7 1.7.3 HDMI-C5SW-R ........................8 1.7.3 Dip Switch for EDID & Audio Settings (SW1 – SW4).............. 9 1.7.4 SW Main Dip Switch for Firmware Update ................ -
Page 3: Section 1: Getting Started
Removal, installation, and set-up service charges. Safety Instructions The Avenview SW-HDMI-C5-4X4 HDMI 1.3 Matrix Switch over CAT5 has been tested for conformance to safety regulations and requirements, and has been certified for international use. However, like all electronic equipment’s, the SW-HDMI-C5-4X4 should be used with care. Read the following safety instructions to protect yourself from possible injury and to minimize the risk of damage to the unit. -
Page 4: Regulatory Notices Federal Communications Commission (Fcc)
Introduction The Avenview SW-HDMI-C5-4X4, HDMI over CAT5 Matrix with IR Pass-through provides the most flexible and cost effective solution in the market to route high definition video sources plus multi-channel (up to 7.1 channel) digital audio from any of the four HDMI sources to the remote displays at the same time. Through low cost Cat-5/5e/6 LAN cables, not only high quality video and audio can be transmitted to the display sites, but also users can switch among four HDMI sources using the push-in button or remote control. - Page 5 www.avenview.com...
-
Page 6: Package Contents
Easy installation with rack-mounting and wall-mounting designs for master and receiver respectively Fast response time – 2~5 seconds for channel Package Contents Before you start the installation of the converter, please check the package contents. SW-HDMI-C5-4X4 HDMI-C5SW-R IR Transmitter IR Receiver... -
Page 7: Panel Description
Panel Description 1.7.1 SW-HDMI-C5-4X4 Front Panel 1. Power: Power Control 2. Seven Segment LED Indicators 3. Front Panel Push Buttons 4. IR Receiver 1.7.2 SW-HDMI-C5-4X4 Rear Panel 1 2 3 1. RS232 2. Power Jack 3. SW Main: DIP Switches 4. -
Page 8: Hdmi-C5Sw-R
1.7.3 HDMI-C5SW-R 1. 5V DC Power jack 2. HDMI Signal 3. IR Signal 4. INPUT # 5. Input Select 6. EQ Level 7. HDMI OUT 8. IR Transmitter www.avenview.com... -
Page 9: Dip Switch For Edid & Audio Settings (Sw1 - Sw4)
[1]. Power off the SW-HDMI-C5-8X8. [2]. Set the DIP switch position to Firmware Update Mode. [3]. Power on the SW-HDMI-C5-8X8. [4]. Power off the SW-HDMI-C5-8X8. [5]. Set the DIP switch position to Normal Operation Mode. [6]. Power on the SW-HDMI-C5-8X8. www.avenview.com... - Page 10 IR emitter extension cable connected here can only transmit IR command signals from the remote receivers that are setting at the input channel 3. IR emitter extension cable connected here can only transmit IR command signals from the remote receivers that are setting at the input channel 4. www.avenview.com...
-
Page 11: Supported Ir Data Formats
SONY 20 BIT CODE RCA CODE RCM CODE MATSHUSHITA CODE MITSUBISHI CODE ZENITH CODE JVC CODE M50560-001P MN6125H MN6125L MN6014-C5D7 MN6014-C6D6 MC14457P LC7464(AHEA) GEMINI-CM www.avenview.com... -
Page 12: Installation (Sw-Hdmi-C5-4X4)
Connect each TMDS output on the SW-HDMI-C5-4X4 to respective TMDS input on the remote receiver HDMI-C5SW-R Connect IR emitter cable to the SW-HDMI-C5-4X4 and direct the IR emitter to the build-in IR receiver of the sources Connect the +5V 6A DC power supply to the SW-HDMI-C5-4X4... - Page 13 If the setting is correct, the corresponding LED will flash. If there is no response, please wait until the LED stops flashing, and try again. Left button to switch channels in ascending order (1, 2, 3, 4, 1, ...) Right button to switch channels in descending order (1, 4, 3, 2, 1, …) www.avenview.com...
-
Page 14: Display Side
Switch output port in descending order 1.10.2.2Method C: IR Remote Control for Controlling the HDMI Sources Users can use the corresponding IR remote to control respective DVD player or any HDMI compliant devices including SW-HDMI-C5-4X4 itself with IR control at any display site. www.avenview.com... -
Page 15: Rs232 Serial Port Control
Select the RS232 serial port connected to the machine. And set device ID 255 is for all device. Only the same device id or 255 can get the command you sent. Press OK. Get the new status from the machine you select. Setting: Press Get button to read back device ID. www.avenview.com... - Page 16 Release output selection. Select Input1~8-Output: Select Input Source. Then select the output port icon. For example: Select input source 1. Then select output port one and two. The video and audio will be sending to port one and two. www.avenview.com...
- Page 17 The linking line will change to yellow. Group setting First select output ports one by one. Then select the input source. The selected output ports change the setting at the same time. By using Terminal: Baud rate: 9600 Data length: 8bit Parity check: Stop bit: www.avenview.com...
-
Page 18: 1Rs232 Commands
Command Code Response Description Data Check SUM 0x08 0x4d 0x41 0x51 0x44 0x05 *0x01~0xff 0x31~0x2f 0xaa SET SW-HDMI-C5-4X4 Device ID *0x01~0xff 0x0c 0x4d 0x41 0x51 0x44 Set SW-HDMI-C5-4X4 Source Device_Id 0x02 port1 port2 port3 port4 0x0c+…+port4 0xaa Mapping of Output Port... -
Page 19: Section 2: Specifications
Section 2: Specifications Item Description Units SW-HDMI-C5-4X4 HDMI-C5SW-R Unit Description 4X4 HDMI Matrix Switch over CAT5 HDMI 1.3 Receiver over CAT5 HDMI Compliance HDMI 1.3c HDCP Compliance Video Bandwidth Single Link 225 MHz (6.75Gbps) Supported Resolutions 480i / 480p / 720p / 1080i / 1080p60... - Page 20 LAN cables. For resolution greater than 1080i or 1280x1024, a CAT6 cable is recommended. 7. If your HDMI display has multiple HDMI inputs, it is found that the first HDMI input [HDMI input #1] generally can produce better transmission performance among all HDMI inputs. www.avenview.com...
- Page 21 Disclaimer While every precaution has been taken in the preparation of this document, Avenview Inc. assumes no liability with respect to the operation or use of Avenview hardware, software or other products and documentation described herein, for any act or omission of...
Need help?
Do you have a question about the SW-HDMI-C5-4X4 and is the answer not in the manual?
Questions and answers