Video walls video processors video matrix switches extenders splitters wireless cables & accessories 4 x 4 hdmi hdbaset lite cat5e/6/7 matrix
with 3d support and bi-directional ir (21 pages)
Hdmi 1.3 matrix switch receiver over cat5 with ir pass-through (11 pages)
Summary of Contents for Avenview SW-DVI-2X4
Page 1
No license, whether express, implied, or otherwise, to any intellectual property rights is granted by this publication. Except as set forth in Avenview Standard Terms and Conditions of Sale, Avenview assumes no liability whatsoever, and disclaims any express or implied warranty, relating to its products including, but not limited to, the implied warranty of merchantability, fitness for a particular purpose, or infringement of any intellectual property right.
Removal, installation, and set-up service charges. Safety Instructions The SW-DVI-2X4 DVI Matrix has been tested for conformance to safety regulations and requirements, and has been certified for international use. However, like all electronic equipments, the SW-DVI-2X4 should be used with care. Please read and follow the safety instructions to protect yourself from possible injury and to minimize the risk of damage to the unit.
Any input can be switched into any output through a remote control. To simplify the switching process, SW-DVI-2X4 comes with an IR remote control. If you don’t have an IR remote control nearby, SW-DVI-2X4 can also be configured by two DIP switches (one rotary switch and one DIP switch).
Package Contents Before you start the installation of the converter, please check the package contents. SW-DVI-2X4 DVI Y Cable IR Remote Control Power Adapter (+5VDC) User’s Manual Before Installation Put the product in an even and stable location. If the product falls down or drops, it may cause an injury or malfunction.
Panel Description FRONT PANEL 1. DVI Output Connector 1 REAR PANEL 3. 5V DC Power 5. DIP Switch 7. Power Indicator 2. DVI Output Connector 2 4. DVI Input Connector 6. EDID LED Indicator 8. IR Receiver www.avenview.com...
DIP Switch 1 should always be set to ON When you need to configure the SW-DVI-2X4 by DIP switch, set the DIP Switch 2 at ON. Set it to OFF only when you need to control the device with provided remote control...
Note: Only four arrow buttons and the menu buttons are currently active. Section 2: Installation Follow these instructions for installation of SW-DVI-2X4: 1. Connect DVI Y Cable to DVI Input 2. Connect DVI Y Cable to DVI Output 2 and DVI Output 3 3.
Weight Power Supply Power Consumption Operating Temperature Storage Temperature Relative Humidity Description SW-DVI-2X4 (DVI Matrix Switch) 1.65 Gbps 1080p60, WUXGA (1920x1200@60) 1 x DVI 2 x DVI DVI-I 29 pin female (digital only) IR Remote 5.1” x 4.3” x 1” (L x W x H)
Page 10
Disclaimer While every precaution has been taken in the preparation of this document, Avenview Inc. assumes no liability with respect to the operation or use of Avenview hardware, software or other products and documentation described herein, for any act or omission of...
Need help?
Do you have a question about the SW-DVI-2X4 and is the answer not in the manual?
Questions and answers