Cmos Clear (Jp5) - SOYO SY-K8USA DRAGON Ultra User Manual

Hardware Installation
G. CMOS Clear (JP5)
In some cases the CMOS memory may contain wrong data, follow the steps
below to clear the CMOS memory.
1. Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5.
This jumper can be easily identified by its white colored cap.
2. Then put the jumper back to 1-2 to allow writing of new data into the
CMOS memory.
CMOS Clearing
JP5 Setting
Note: You must unplug the power cable from your power supply
connector when performing the CMOS Clear operation.

CMOS Clear (JP5)

Pin Assignment
GND
Clear CMOS Data
Short pin 2-3
for at least 5
seconds to
clear the
CMOS
SY-K8USA DRAGON Ultra
RTC NC
Retain CMOS Data
Short pin 1-2
to retain new
settings
1 2 3
40
1 2 3