SOYO SY-K8USA DRAGON Ultra User Manual page 14

Motherboard Description
DDR DIMM Banks
These 2, 184 pin memory slots are to install your system memory in.
H
They support up to 2 GB of memory. For more details check the Step
2 Install Memory Module paragraph on page 18.
Floppy Disk Drive (FDD) connector
This 34 pins connector is to connect your floppy drive to. Check for
I
more details in the B. Floppy Drive Installation paragraph on page
24.
Chassis Cooling Fan (CHAFAN1, 2, 3) Connectors
This connector is to connect your chassis fan to your motherboard.
This motherboard supports up to 3 chassis fans. Please check the (2)
J
Chassis Cooling Fan (CHAFAN1, CHAFAN2, CHAFAN3)
paragraph on page 33 for more details.
Bus Mastering EIDE/ATAPI Ports
These connectors are to attach your IDE devices to. Each connector
K can support up to 2 IDE devices, 1 master and 1 slave. Please check
the IDE Device Installation (HDD, CD-ROM) paragraph on page
22 for more details.
IDE RAID Ports
This IDE port (IDE 3) can be used as normal IDE port or in a RAID
L configuration and are controlled by ALi M5283 chip. ATAPI devices
will not work on these ports. For more details, please check the IDE
Device Installation (HDD, CD-ROM) paragraph on page 22.
ALi M1563 SouthBridge Chipset
The M1563 integrates AC-Link Host Controller, ACPI support,
green function, 2-channel dedicated Ultra-133 IDE Master
M
controller, USB 2.0/1.1 Host controllers with 6 ports in total, SMBus
2.0 controller, Real Time Clock, IO APIC controller, and HTT
(HyperTransport Technology) v1.03 interface.
3V Lithium Battery
This battery supplies power to the CMOS RAM. As long as the
battery supplies enough power, the contents of your CMOS RAM
N
will be valid. CMOS RAM contents are configured by CMOS setup,
and can be cleared by JP5. For more details on this check the G.
CMOS Clear (JP5) paragraph on page 40.
Buzzer
O
On-board ABR buzzer.
SY-K8USA DRAGON Ultra
9