SOYO SY-K8USA DRAGON Ultra User Manual page 100

IDE 3 Driver Installation
IDE 3 DRIVER INSTALLATION
You can use your IDE3 as
1. Normal IDE function.
2. RAID function. (RAID0, 1)
To use IDE3 as normal IDE, please do the following steps
1. Go to the CMOS setup
"Onboard RAID" to "Enable".
2. Install the ALi M5283 driver. See driver installation instruction
below.
To use IDE3 as RAID controller, please do the following steps
1. Connect 2 hard disk on IDE3.
2. Go to the CMOS setup
"Onboard RAID" to "Enable".
3. Go to the CMOS setup
"First Boot Device" to "SCSI".
4. Set the "RAID/ATA,SCSI Boot Order" to "RAID/ATA, SCSI".
5. Press "Ctrl+A" when the Ali M5283 BIOS summary screen
appears.
6. Create a disk array, check appendix A for create instructions.
7. Install the ALi M5283 driver. See driver installation instruction
below.
To boot from the IDE 3
1. Go to the CMOS setup
First Boot Device to "SCSI".
2. Set the "RAID/ATA,SCSI Boot Order" to "RAID/ATA, SCSI".
SY-K8USA DRAGON Ultra
Chapter 5
SOYO COMBO Feature
SOYO COMBO Feature
SOYO COMBO Feature
SOYO COMBO Feature
95
and set the
and set the
and set the
and set the