Using Your Microsentry™ Refrigerator Control; Starting Your Refrigerator; Turning Your Refrigerator On Or Off; Set Temperature - AGA marvel 30ARM Installation, Operation And Maintenance Instructions

USING YOUR MICROSENTRY™ REFRIGERATOR CONTROL
Door Switch

Starting your refrigerator

Plug the refrigerator power cord into a wall outlet. Your
refrigerator will begin cooling after power is applied.
If your refrigerator does not start, check that the refrigerator
is turned on and the set temperature is cold enough.

Turning your refrigerator ON or OFF

If the refrigerator is on, the refrigerator temperature will be
shown on the display. To turn the refrigerator off, press and
hold the "ON/OFF" button for three (3) seconds. "OFF" will
appear on the display.
If the refrigerator is off, "OFF" will be shown on the display.
To turn the refrigerator on, press and hold the "ON/OFF"
button for three (3) seconds. The refrigerator temperature
will be shown on the display.

Set temperature

To set the refrigerator temperature, press and hold the
"SET" button. When the "SET" button is pressed, the
display will show the set temperature. While holding the
"SET" button, press the "WARMER" or "COLDER" buttons
to adjust set temperature.

Refrigerator operation

The available temperature range of the refrigerator is as
follows:
30ARM, 3OARM, 61ARM, and 6ADAM; 33° to 45°
(1° to 7° C)
6ARM, 6ARCM, 6AROM, and MPRO6ARM; 35° to 43°
(2° to 6° C)
It may take up to 24 hours for your refrigerator to reach
desired temperature. This will depend on amount of content
loaded and number of door opening and closings.
For best results allow refrigerator to "pull down" to desired
set temperature before loading. Once contents are loaded,
allow at least 48 hours for temperature to stabilize before
making any adjustments to the set temperature.

Alarms

Your MicroSentry™ refrigerator control will monitor refrig-
erator function and alert you with a series of audible and
visual alarms.
• Door Ajar Alarm: If the door has been left
open for over five (5) minutes, the alarm
will sound in one (1) second intervals. The
display panel will flash "do" and the Alarm LED located at
the top left of the display below the word "Alarm" will be il-
luminated. This will stop as soon as the door is closed.
• Temperature Sensor Fault: If the control
ler detects that the temperature sensor is
not properly functioning, a temperature
sensor alarm will sound in one (1) second intervals. "E1"
will flash on the display panel and the Alarm LED located
at the top left of the display below the word "Alarm" will be
illuminated. Please call AGA MARVEL Customer Service or
your dealer if this error code is displayed.

Alarm Mute

Press any key to mute the audible portion of an alarm.
NOTE-This action will only mute the alarm. If the condi-
tion that caused the alarm continues, the alarm code will
continue to flash and will sound for 20 seconds every 60
minutes.
6
Control
Figure 5