REMOTE CONTROL CONNECTION:
The heater is equipped for connection to an external -wire remote thermostat or a -wire remote switch.
A -wire thermostat has its own temperature sensor for regulating water temperature. A - wire remote switch
allows the "POOL" or "SPA" models to be remotely selected. Connect remote wiring to the terminal block on
the exterior of the control box (see Figure A below). Do not remove the wire harness and attempt to connect
remote controls directly to the ignition control board. Remote wiring must be run in a separate conduit. Use
22 AWG wire for runs less than 30 feet. Use 20 AWG wire for runs over 30 feet. The maximum allowable run
is 00 feet.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Pomona, CA Clemmons, NC Nashville, TN
Tel: 908-351-5400
www.haywardpool.com