Table of Contents
Advertisement
JT-11 Auto Tuner Overview
Your JT-11 comes fully assembled, aligned and mounted in its own shield enclosure. You will
install the tuner inside your Jupiter transceiver, resulting in a fully integrated internal tuner. After
installation, your JT-11 tuner will be controlled by the Jupiter's user interface.
Installation is straightforward; you will mount the tuner inside your Jupiter transceiver, remove
one coax cable and solder four connections.
Installation requires that you unsolder two existing coaxial connections and make three new
solder connections. These are simple steps, well within the abilities of anyone with basic
electronic assembly skills. Simply follow the step-by-step directions, referring to the
accompanying illustrations. Work patiently, read through each step completely before proceeding
and check your work often.
Your workplace should be uncluttered, well lighted and well ventilated, and protected from static
discharge. A grounded static mat is ideal, but you should at least be able to touch a ground point
(light switch, water pipe, etc) from time to time to avoid static buildup.
Installing the JT-11 according to these instructions does not void your Ten-Tec warranty.
4
Advertisement
Table of Contents
