Qwest Q1960 Owner's Manual page 12

QT1960_OM 4/6/01 5:27 PM
If the handset beltclip is
attached, you cannot
charge the handset with
the display showing when
the phone is mounted on
the wall (See page 35).
8
Page 12
Direct wall plate mounting
If you don't have a standard wall plate, you can mount your phone directly to
the wall. Before doing this, consider the following:
• Avoid electrical cables, pipes, or other items behind the mounting location,
that could cause a hazard when inserting screws into
the wall.
• Try to mount your phone within 5 feet of a working phone jack to avoid
excessive cord lengths.
• Make sure the wall material is capable of supporting the weight of the base
and handset.
• Use #10 screws with anchoring devices suitable for the wall material where
the base unit will be placed.
8
On the base unit, pull the handset
retainer out of the slot. Rotate it
clockwise 180 degrees.
9
Flip the retainer from front to
back. Slide it back into the slot so
that the lip of the retainer is up
and the oval is down. The retainer
holds the handset
in place.
1
Insert two mounting screws into
the wall, (with their appropriate
anchoring device), 3-15/16 inches
apart. Allow about 3/16 of an inch
between the wall and screwheads
for mounting the phone.
2
Refer to steps 1 through 9 on pages
7 and 8 to mount the telephone.