Paper Jam - Digital Equipment LG06 Maintenance Manual

Paper Jam

Instruction
1.
Inspect paper path for
bunched, torn, folded paper
or labels.
2.
Inspect the narrow
passageway between the
face of the platen and the
ribbon mask for bits of torn
paper or ribbon lint. Check
the holes in the ribbon mask
surrounding each hammer
tip.
3.
Check that the ribbon mask
has not been deformed in
such a way as to block the
paper path.
4.
Load paper.
5.
Run a diagnostic self–test
(page 3–26).
6.
Run a diagnostic self–test
(page 3–26).
7.
Run a diagnostic self–test
(page 3–26).
8.
Run a diagnostic self–test
(page 3–26).
Troubleshooting
Indication
Paper path is clear.
Debris found.
Ribbon mask damaged or bent.
—
"Paper Jam" message.
"Paper Jam" message.
"Paper Jam" message.
"Paper Jam" message.
Yes
Step 2. Remove paper
and go to step 2.
Gently remove Step 3.
paper or lint
particles with a
wooden stick or
pair of tweezers.
CAUTION: Do not
pry or apply force
to the hammer
tips. Go to step 3.
Replace the Step 5.
hammer bank
cover assembly
(page 5–22). Go
to step 5.
Step 5.
Clean the paper Return printer to
motion detector normal operation.
with cotton swab.
Go to step 6.
Replace paper Return printer to
detector switch normal operation.
assembly (page
5–76). Go to step
7.
Replace the Return printer to
intermediate cable normal operation.
assembly (W5)
(page 5–10). Go
to step 8.
Replace the Return printer to
common controller normal operation.
PCBA (page
5–46).
No
—
3–11