Reassembly Procedures (Difference) - Subaru EH72 FI Service Information

4-4 REASSEMBLY PROCEDURES (DIFFERENCE)

20) COOLING FAN
Attach cooling fan onto flywheel .
M6 x 16 bolt & washer : 4 pcs .
Tightening torque
6.8 - 8.8 N•m
(70 - 90 kgf•cm)
(5.1 - 6.5 ft•lb.)
21) THROTTLE BODY
(1) Replace the gasket of manifold with a new
one and mount the throttle body on the
intake manifold .
(2) Replace the gasket of throttle body with a
new one and mount the cleaner adapter on
the throttle body .
M6 FLANGE NUT : 4pcs .
Tightening torque
6.8 - 8.8 N•m
(70 - 90 kgf•cm)
(5.1 - 6.5 ft•lb.)
(3) Connect the connectors from ECU to the injectors .
22) IGNITION COIL and WIRE CP
(1) Temporally fit ignition coil to crankcase .
Adjust air gap between ignition coil and flywheel using a thickness gauge and tighten bolts .
Ignition coil air gap
0 .3 - 0 .5 mm
(0 .012 - 0 .020 in .)
M6 x 30 bolt & washer : 4pcs .
Tightening torque
6.8 - 8.8 N•m
(70 - 90 kgf•cm)
(5.1 - 6.5 ft•lb.)
(2) Connect wiring from ECU to the primary
terminal of ignition coil .
(3) Clamp the wiring harness with wire bands
to the intake manifold .
THROTTLE
BODY
CLEANER
ADAPTER
WIRING
HARNESS #1
- 9 -
INTAKE
MANIFOLD
GASKET
INJECTOR
GASKET
WIRING
HARNESS #2