Honda 08B06-SDA-100 Installation Instructions Manual page 9

21. Attach the two grommet screws to the player
panel in the square holes shown.
GROMMET
SCREW
22. Using scissors, cut one EPT sealer into three
pieces.
EPT SEALER
(Cut off the
marked area.)
EPT SEALER
23. Using isopropyl alcohol, clean the player panel
where the EPT sealers will attach. Attach the EPT
sealer to the player panel, and cut off the excess.
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
24. Insert the player panel clips into latches, and
PLAYER
PANEL
2306131T
25. Check that all wire harnesses are routed properly
26. Reconnect the negative cable to the battery.
PLAYER
27. Enter the customer's radio anti-theft code, and
PANEL
28. Set the clock.
29. Check the operation of the player according to the
30. Put the player Owner's Manual in the glove box.
31. Reinstall all removed parts.
8 mm
32. Start the engine. Push down fully on the driver's
33. Pull up fully on the driver's window switch to close
8 mm
34. Use the window switch to check the window
2612010T
AII 25716-25817 (0404)
attach the player panel to the instrument panel
with the two self-tapping screws you removed in
step 5. Remove the masking tape.
CLIP
PLAYER
PANEL
SELF-TAPPING
SCREW (reused)
and all connectors are plugged in.
reset the radio station presets.
its Owner's Manual.
NOTE: Whenever the battery is disconnected, the
driver's window AUTO function is disabled.
window switch until the window is fully open.
the window completely, then hold the switch for
2 seconds or more.
AUTO function.
LATCH
2306141T
9 of 9