Molded is better! Manual Override: Works day or night. No leaky gaskets or bug hotels with SmartBox. The hard lens is molded as part of the case. Double flip wall switch logic prevents Detection Zone: It’s vandalproof, rainproof, bugproof and absolutely sealed.
Assembly and Wiring • All wiring MUST comply with local Basic Wiring Diagram Note: The SmartBox time control is factory set electrical codes and should be installed by for 5-8 minutes and for night only operation. qualified electrician. For other settings, see “Aiming and Walk Testing”...
Wiring Diagrams How Does RAB’s SmartBox Work? To override sensor with a manual switch How are the Time, Sensitivity and The SmartBox infrared sensor “sees” Photocell adjusted? small temperature changes caused by the motion of people or cars within TimeControl: Sets the time that lights...
4. The Time Control is factory set between detection both at long and close range • SmartBox may be painted to blend in • For the first 30 seconds, the lights will be 5-8 minutes. This period starts after with walls.
Page 6
If it moves, tighten all screws. from lights. by tilting sensor 1/16”. This small 3. Make sure that SmartBox is not mounted adjustment may move the zones to on an unstable object such as a tree or allow earlier detection.
Page 7
Technical Tips: Lights Turn Off Technical Tips: Lights Do Not Turn On Too Quickly Lights Turn On and Off Incorrectly 1. Check that lamps and fixtures work. 1. Check if sensor is being “tricked” by 1. Make sure the sensor is installed on its 5.Make sure lights are not visible from or Compare wiring to the Wiring Diagram reflected light.
Page 8
Product Warranties Reasons 1. Lights may turn on occasionally during The RAB SmartBox will be free from defects in The following warranties apply to RAB Lighting, Inc. (“RAB”) buyer shall be liable for reasonable attorney’s fees, interest and products that meet all of the following conditions: (a) the costs of collection.