Download Print this page

Appendix A - Nutone Systems - NuTone NM100WH Instructions Manual

Nm100 series
Hide thumbs Also See for NM100WH:

Advertisement

The door release switch contacts are very versatile and can be
used with many AC/DC door or switch contacts. Be sure to use
the wire and power supply or transformer specified by the door
or gate release product being used.
paNic iNterface WitH security system
Run a line of 18 gauge solid copper, twisted pair approved
low voltage cable from the NWH300 or NWH300C rough-in
location to the security control panel. Setup the security panel to
receive a normally open dry contact for panic operation. (Refer
to programming procedures accompanying the security panel).
Label and secure cables at the NWH300 or NWH300C rough-
in. Have a certified security installer hook the NM100 up to the
alarm system.
testiNg
After all connections have been made, insert the NM100 power
plug into NA300TA transformer and secure the master to the
rough-in using the 2 screws provided. If using the NF200CWH,
NF100CWH or NF100MWH frame with a NC300 player, install
the master unit over the frame. Do not over tighten the screws
as the plastic may distort or crack. Install the speaker panel on
the master as shown.
Please be careful to only apply pressure on the speaker panel
at the corners and not in the middle. Check all functions by
following the guidelines in the Owners Manual shipped with
the master unit. If any difficulties are encountered, recheck all
connections. If after reviewing these instructions you are unable
to resolve any problems, contact technical support at 1-888-
336-6151.
appeNdix a - NutoNe
systems
*Refer to frames below:
• NF100MWH – Replacing a master only system with an
NM100 master
• NF100CWH – Replacing a combination system with an
NM100 master and NC300 CD player
• NF200CWH – Replacing a master only system with an
NM100 master and NC300 CD player (requires hole in wall
to be made larger)
• NF300RWH – Used on all indoor remote station
replacements
• NF300PWH – Used on all outdoor or high sun area flush
mount remote station replacements
• NRKS200PWH – Used on all outdoor surface mount
remote station replacements
• NF300DWH – Used on older NuTone door station
replacements, not required for M&S replacements
100
model Nm
WH
Page 

Advertisement

loading