Pioneer DVR-RT500-S Service Manual page 99

5
1-4: POWER PCB (Refer to Fig. 1-4)
1. Remove the 2 screws 1.
2. Disconnect the following connector: (CP506).
3. Remove the Fan Motor in the direction of arrow (A).
4. Remove the 3 screws 2.
5. Disconnect the following connector: (CP1701).
6. Remove the Power PCB in the direction of arrow (B).
2
(B)
1-5: VCR DECK (Refer to Fig. 1-5)
NOTE:
Do not remove the cable at the FE Head section. The FE
Head may be damaged if you remove the cable by force.
1. Unlock the 2 supports 1 and remove the Top Holder.
2. Remove the screw 2.
3. Remove the FE Head.
4. Move the Cassette Holder Assy to the back side.
5. Remove the 3 screws 3.
6. Disconnect the following connectors:
(CP101, CP102, CP3001).
7. Remove the AC Head Cover and VCR Deck in the
direction of arrow.
3
3
2
FE Head
VCR Deck
5
6
2
Power PCB
2
Fan Motor
(A)
1
1
Bottom Plate
Fig. 1-4
3
AC Head Cover
Top Holder
1
1
Fig. 1-5
DVR-RT500-S
6
7
1-6: VCR PCB (Refer to Fig. 1-6)
1. Remove the screw 1.
2. Remove the screw 2.
3. Remove the 7 screws 3.
4. Remove the Jack Shield.
5. Remove the VCR PCB in the direction of arrow.
2
Jack Shield
Bottom Plate
7
8
VCR PCB
1 3
3
3
3
3
3
3
Fig. 1-6
99
8
A
B
C
D
E
F