Power Supply - Panasonic Digital Palmcorder MultiCam PV-GS65 Operating Instructions Manual

Power supply

ª
Charging the battery
When this product is purchased, the battery is not
charged. Charge the battery before using this
product.
≥Battery charging time (
≥We recommend using Panasonic batteries.
≥If you use other batteries, we cannot guarantee
the quality of this product.
≥If the DC input lead is connected to the AC
adaptor, then the battery will not charge.
Remove the DC input lead from the AC adaptor.
1
Connect the AC cable to the AC adaptor and
the AC jack.
2
Put the battery on the battery mount by
aligning the mark, and then securely plug it
in.
ª
Charging lamp
Lights up: Charging
Goes off: Charging completed
Flashing: The battery is over discharged
(discharged excessively). In a while,
the lamp will light up and normal
charging will start.
When the battery temperature is
excessively high or low, the [CHARGE]
lamp flashes and the charging time will
be longer than normal.
14
LSQT0860
Before using
)
-15-
ª
Connecting to the AC outlet
1
Connect the AC cable to the AC adaptor and
the AC jack.
2
Connect the DC cable to the AC adaptor.
3
Connect the DC cable to this product.
≥The output plug of the AC cable is not
completely connected to the AC adaptor jack.
As shown in 1, there is a gap.
≥Do not use the power cord for other
equipment since the power cord is exclusively
designed for this Camcorder. Do not use the
power cord from other equipment for this
Camcorder.
ª
Fitting the battery
Push the battery against the battery holder and
slide it until it clicks.
ª
Removing the battery
While pushing the [PUSH BATT] button, slide the
battery (or the DC input lead) to remove it.
≥Hold the battery with your hand so it does not
fall.
1
PUSH
BATT