Lsqt0860 - Panasonic Digital Palmcorder MultiCam PV-GS65 Operating Instructions Manual

ª
Remote control usable range
≥The distance between the remote control and
the Camcorder: Within approx. 15 feet (5 m)
Angle: Approx. 10o up and 15o down, left, and
right
ª
Selecting the remote control mode
If 2 Camcorders are used simultaneously, set the
mode for one pair of Camcorder and remote
control to [VCR1] and that of the other pair to
[VCR2]. This will prevent interference between
the 2 pairs. (The default setting is [VCR1]. When
the button-type battery is replaced, the setting will
revert to the default [VCR1].)
1
Setting on the Camcorder:
Set [SETUP] >> [REMOTE] >> [VCR1] or
[VCR2].
2
Setting on the remote control:
STILL ADV
2
[VCR1]:
Press [D] and [∫] simultaneously. 1
[VCR2]:
Press [E] and [∫] simultaneously. 2
VOL
PAUSE STILL ADV
1
STOP
VAR
Before using
ª
Concerning the button-type battery
≥When the button-type battery runs down,
replace it with a new battery (part number:
CR2025). The battery is normally expected to
last about 1 year, but it depends on operation
frequency.
≥Keep the button-type battery out of the reach of
children.
≥If the remote control mode of the Camcorder
and that of the remote control do not match with
each other, "REMOTE" will appear. When the
remote control is operated for the first time after
the Camcorder is turned on, "CHECK REMOTE
MODE" (
-54-
impossible. Set the same remote control mode.
≥The remote control is intended for indoor
operation. Outdoors or under strong light, the
Camcorder may not operate properly even
within the usable ranges.
≥Within a 3 feet (1 m) range, you can operate the
remote control using the remote control sensor
on the LCD monitor side of the Camcorder.
) will appear and operation is
23

LSQT0860