Plenum Mount - Black Box SmartPath LWN602A User Manual

Chapter 3: The SmartPath AP (LWN602HA) Overview

3.5.2 Plenum Mount

To mount the SmartPath AP in the plenum space above a dropped ceiling grid, you need the mounting plate, hanger clip, and a
standard 24"-wide hanger frame, which can be ordered separately (call Black Box Technical Support at 724-746-5500 for details).
1. With the recessed side of the mounting plate facing downward, insert the hanger clip through the large hole in the center of
the plate.
2. Squeeze the clip until the projecting tabs at the ends of its two feet snap into the smaller holes on both sides of the larger hole
(see Figure 3-15).
Insert the hanger clip through the large hole in the mounting plate.
Squeeze the hanger clip to pull the tabs on its feet inward until they snap upward into the two holes on either side of the larger
hole.
Hanger clip
3. Attach the SmartPath AP to the mounting plate, and then attach the antennas to the connectors (see Figure 3-16).
side view
(side view)
3
With the SmartPath AP upside
down, align its port side with
the bottom end of the plate.
Push the SmartPath AP
upward, inserting the four tabs
on the plate into the four slots
on the SmartPath AP.
Slide the SmartPath AP toward
the bottom end of the plate,
locking the tabs inside the slots.
Attach the antennas to the
antenna connectors.
Page 50
Mounting
plate
Figure 3-15. Fitting the hanger clip to the mounting plate.
Mounting Plate
Mounting Plate
SmartPath AP (shown as transparent for clairty)
Tab
Slot
Figure 3-16. Attaching the SmartPath AP to the mounting plate.
724-746-5500 | blackbox.com
Tab Tab
inside locked in
slot. place.