Federal Communication Commission Interference Statement; Fcc Radiation Exposure Statement - Black Box SmartPath LWN602A User Manual

FCC Statements

Federal Communication Commission Interference Statement

Each Black Box product described in this manual complies with part 15 of the FCC Rules when operating under the following
restrictions: (1) This device may not cause harmful interference, and (2) they must accept any RF interference received, including
interference that might cause an unwanted impact on their operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment.
Important: FCC Regulatory Warning Notices
LWN602A devices are restricted to indoor use due to their operation in 5 GHz frequencies, which are shared by mobile satellite
systems and government radar systems. The FCC requires that these products only be used indoors to reduce the potential for
harmful interference with co-channel radar that might be operating in the 5.25–5.35 or 5.47–5.725 GHz frequency ranges in the
same area. The conflicting activity of radar stations and these devices can cause interference or damage to each other. In addition,
these devices have a radar detection function that might interrupt normal operations when they detect a radar signal. To reduce
the risk of interference even further, installing these devices away from windows is recommended.
LWN602A devices operating within the 5.15–5.25 GHz frequency range are restricted to indoor environments.
The FCC region code is set in the device during the manufacturing process, the option to set it to any region other than FCC is
disabled, and the country code selection function has been completely removed from all U.S. models. It is impossible for the end
user to change the region to anything other than FCC.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with a minimum distance of 23 centimeters (9 inches) between the radiator and your body.
The availability of some specific channel and/or operational frequency bands are country dependent and are firmware
programmed at the factory to match the intended destination. The firmware setting is not accessible by end user.
Only attach antennas that are certified for use with this device. Replacing antennas with unauthorized, high-gain antennas greatly
increases the risk of interference and invalidates the FCC certification.
724-746-5500 | blackbox.com
Page 3