Smart Poe - Black Box SmartPath LWN602A User Manual

T568A and T568B are two standard wiring termination schemes. Note that the only difference between them is that the white/
green + solid green pair of wires and the white/orange + solid orange pair are reversed.
For straight-through Ethernet cables—using either the T568A or T568B standard—the eight wires terminate at the same pins on
each end.
For cross-over Ethernet cables, the wires terminate at one end according to the T568A standard and at the other according to
T568B.

3.2.1 Smart PoE

The SmartPath AP (LWN602HA) applies the concept of smart PoE to adjust power consumption as necessitated by varying levels
of available power. The SmartPath AP supports PoE on both its ETH0 or ETH1 interfaces and can draw power through either one
or through both simultaneously. Based on the available power that the SmartPath AP detects, it manages its internal power use
by making the following adjustments:
Chapter 3: The SmartPath AP (LWN602HA) Overview
Figure 3-4. T568A Terminated Ethernet Cable with an RJ-45 connector.
Figure 3-5. T568B Terminated Ethernet Cable with an RJ-45 connector.
724-746-5500 | blackbox.com
Table 3-3. T568A Wire
Color.
Pin T568A Wire Color
1 White/Green
2 Green
3 White/Orange
1
4 Blue
5 White/Blue
8
6 Orange
7 White/Brown
8 Brown
Table 3-4. T568B Wire
Color.
Pin T568A Wire Color
1 White/Orange
1
2 Orange
3 White/Green
8
4 Blue
5 White/Blue
6 Green
7 White/Brown
8 Brown
Page 39