Maintenance And Service - Magnum 257060 Operation

Maintenance and Service

Maintenance and Service
NOTICE
Protect the internal drive parts of this
sprayer from water. Openings in shroud allow
cooling of mechanical parts and electronics
inside. If water gets into these openings, the
sprayer could malfunction or be permanently
damaged.
Caring for Sprayer
Keep sprayer and all accessories
clean and in good working order.
To avoid overheating motor, keep
vent holes in shroud clear for air
flow. Do not cover sprayer while
spraying.
Paint Hoses
Check hose for damage every time you spray. Do not
attempt to repair hose if hose jacket or fittings are dam-
aged. Do not use hoses shorter than 25 ft (7.6 m).
Wrench tighten, using two wrenches.
26
Tips
• Always clean tips with compati-
ble solvent and brush after
spraying.
• Tips may require replacement
after 15 gallons (57 liters) or they
may last through 60 gallons (227
liters) depending on abrasive-
ness of paint.
• Do not spray with worn tip.
Pump Packings
When pump packings wear, paint
will begin to leak down outside of
pump.
ti3388a
• Replace pump packings at
first sign of leaking or addi-
tional damage could occur.
• Purchase a pump repair kit
and install according to
instructions provided with kit.
• Consult a Graco/M
authorized service center.
ti9355b
AGNUM
ti2055a
ti9356a
313034G