Loading The Wmb Inline - WAGO TP298 Manual

6.4.

Loading the WMB Inline

Make sure that the device is turned off.
The insertion of the WMB Inline (2009-115) is performed analog to the insertion of the marking strip.
Please note the following:
The spool must be inserted in such a manner that the upper side of the labels is printed and the
follow-up guidance of the labels is assured. The spool, the red strip guidance and the material should
be aligned to a straight line.
Sensor alignment:
Verify the correct setting by turning the printer on and waiting until the FEED button lights up. Now
press once on FEED. 8 labels will be pulled forward (calibration length). If, upon each FEED
actuation, only one label is pulled forward, then the printer is ready for operation.
The sensor should be aligned to the left edge of the label,
not centered to the label strip.
TP298
23