Inscription Using Smartmarking - WAGO TP298 Manual

Number of print-outs
(= Number of copies)
Print separating line
The separating lines can be deactivated here.
Printer selection
Here you activate the desired printer for printing the strip.
Settings for WMB Inline are performed in the same manner, however, the separating lines cannot be
set, because separating lines are not printed in WMB Inline in principle, since WMB Inline is
stretchable and can equalize certain tolerances.
8.3.

Inscription using smartMARKING

This section provides a short introduction to the printing of WAGO marking strips with your new
TP298.
You start by creating a new project (Button New or menu File >New). As output device, please select
TT Printer (Roll).
Upon clicking Accept you reach the list of output devices after selecting the TT printer. All possibly
connected thermal transfer printers are available here. Upon opening the tab Printer you have
access to the installed printer drivers and can select the output device by clicking on the button
Apply.
36
TP298