Start-Up Support - WAGO TP298 Manual

1.1.

Start-up support

This section contains information required by you to begin working with WAGO inscription devices.
We have summarized the following data for you:
Preset values for marking strip 2009-0110 in smartDesigner
Preset values for WMB Inline 2009-0115 in smartDesigner
IMPORTANT: Maintenance information for your thermal transfer printer
Local Settings
The local settings can be changed in the printer's menu. This procedure is shown in detail in the
following example of changing the country from Germany to USA.
First press the "Menue" button on the printer. "Kurzstatus" appears on the display. Click twice on the
right arrow until "Einstellungen" is displayed, followed by one click on the down arrow.
"Regionaleinst." appears on the display.
Now click the down arrow. The display shows "Land-Deutschland". Then press the centre button of
the arrow pad. Your country can be selected using the left/right arrow keys (e.g. USA). Once you
have selected your country, click the ENTER button.
Clicking the up arrow takes you back to the main folder. "Local settings" is now shown on the
display. Press the up arrow key again and the display will show "Setup". Press the left arrow three
times to close the menu. "Ready" is displayed and the setting is complete.
1.1.1.
Preset values for WAGO smartDESIGNER
Prior to delivery, the TP298 printer was preset specifically for "marking strips" and "WMB Inline".
BEFORE you may print a marking strip, please note the printer driver installation in this manual and a
short description of the WAGO ProServe software.
Here you can see the position of the WAGO inscription products marking strips (left) and WMB
Inline (right). Please do not attempt to use both products at the same time!
TP298
5