Printer Preparation; Loading The Thermal Transfer Ink Ribbon - WAGO TP343 Manual

5. Printer preparation
5.1. Loading the thermal transfer ink ribbon:
Please use the following ink ribbons for WAGO labeling materials:
Resin film (Order No. 258-145)
Resin film (Order No. 258-150)
Resin-wax film (Order No. 258-144)
To load the ink ribbon, press the lever (Fig. 5) forward to open the print head. Raise the
top part of the printer as far as the stop.
CAUTION: Do not force the top part of the printer closed, as this may break the catch. To
close, simply raise the top part slightly, the printer will then close automatically.
CAUTION: When closing, please be careful not to trap fingers between the top and
bottom printer unit.
<___
Now, remove the printer's roll holder by pushing it gently to the left against the spring.
After unpacking the ink ribbon, slide it onto the rear roll holder. Please ensure that the mat
side is unwound so that it comes into contact with the labeling material.
8
Fig.5
Fig.7
<___
Thermotransferdrucker TP 343
for markingSTRIP (Order No. 2009-110)
for conductor identification material Series 211
for label material
Fig.6