Setting Up Your Jet Sweep Blower - Troy-Bilt 670 Series Operator's Manual

3
Setting
Up Your
Jet Sweep
Blower
WARNING
Keep hands out of
inlet and discharge
openings while
machine is running.
There are rotating
blades inside.
DO NOT operate
without shields
and guards (eg.,
discharge chute,
air intake guard) in
place.
IMPORTANT
This unit is shipped
without gasoline or
oil in the engine. Fill
up gasoline and oil
as instructed in the
accompanying engine
manual BEFORE
operating your jet
sweep blower.
Figure 3-1
Figure 3-2
1
3
2
Figure 3-3
IMPORTANT: This unit is shipped without gasoline or
oil in the engine. Fill up gasoline and oil as instructed
in the accompanying engine manual BEFORE operat-
ing your jet sweep blower.
NOTE: Reference to right or left hand side of the jet
sweep blower is observed from the operating position.
Loose Parts In Carton
1. Upper Handle
2. Chute Attachment
3. Operator's Manual
Attaching The Upper Handle
1. Remove the carriage screws and star knobs from the
upper holes in the lower handle. See Figure 3-1.
2. Place the upper over the lower handle, aligning the
upper holes/metal tabs in the upper handle with the
upper holes/lower holes in the lower handle. See
Figure 3-2.
3. Secure with the carriage screws and star knobs
removed earlier. See Figure 3-2.
Attaching The Chute Attachment
1. Raise blower direction lever to the highest position.
See Figure 3-3.
2. Slide chute attachment down over blower opening.
3. Lower blower direction lever to middle position to lock
chute attachment. See Figure 3-3.
WARNING: Keep hands out of
inlet and discharge openings
while machine is running. There
are rotating blades inside.
WARNING: DO NOT operate
without shields and guards (eg.,
discharge chute, air intake guard)
in place.
6