Connecting A Sip Set To The Lan; Connecting Power Supply (Optional); Configuring The Generic Sip Set - Alcatel-Lucent OmniPCX Office Installation Manual

9. A virtual MAC Address is automatically generated but it can be replaced by the real MAC
Address of the SIP device.
Note:
The MAC Address must be unique and is used to identify the subscriber in the OmniPCX Office call
handling (SIP password is used for authentication).
10. Note this new password safely. It will be requested during the generic SIP set configuration
(

Configuring the generic SIP set

Connecting the Set
This section describes how to:
- Connect a generic SIP set to the LAN (Local Area Network)
- Connect the power supply
Prerequisites
None

Connecting a SIP set to the LAN

Note:
If the set is supplied via Ethernet, ensure you are using a 802.3af standard-compatible switch.
To connect the set to the LAN:
- Plug the RJ45 cable into the set's LAN connector.
- Connect the RJ45 cable to the LAN.

Connecting Power Supply (Optional)

To supply power via an AC/DC external adapter:
- Plug the appropriate cable from the adapter into the set's power supply connector.
- Connect the plug from the adapter to the mains power supply.
Configuring the generic SIP set
The following parameters must be entered through the MMI or web interface when available:
- IP address (if no DHCP server is configured)
- Subnet mask (if no DHCP server is configured)
- Gateway adress (if no DHCP server is configured)
- DNS adresses (if no DHCP server is configured)
- VLAN use (if no DHCP server is configured)
- VLAN ID if VLAN use is set (if no DHCP server is configured)
- SIP username
- SIP password: this is different from the user password. It is randomly generated for each
SIP phone by the system and must be provided to the user in a secured way. It is used
both for SIP registration and for SIP authentication, since every SIP message must be
authenticated.
).
4-47