Important Points - Sanyo SHP-TH90GDN-SW Technical Manual

General information
Note
instructions
Upon delivery and installation carefully check the following important points:
ck the product and check before installation that it has not been
damaged during transport.
Report eventual transport damage to the transporters.
yo CO2 Eco must be transported in upri
When moving the tank unit to the inside of the house, it can temporarily be laid down on
its back.
ct is placed in a room with soft carpeting, bottom plates to be
be placed under the adjusting feet of the product is recommended.
re that the product stands straight. Check with a water level.
ste water pipe from the mounted safety valve is drawn to
the floor drain.
The current sensors shall always be mounted. The boiler detects what
phase the heat pump is mounted, and
electrical heater.
Important :
1. When the heat pump unit is connected and the system has been water filled, please allow
the heat pump operation by
display to allow the load circulation pump to run. Otherwise there may be a water freeze risk if
the ambient temperature is below 0ºC.
2. the heat pump unit is not connected: be sure the
E
damaged.
The following safety instructions must be observed upon handling, installation
and use of the product.
ar on the cold water connection, see chapter
g valve to the hot tap water to prevent scalding, see chapter
the product is currentless before any interventions.
the boiler with water.
ndling the product with a lifting eye, make sure that the lifting
tackle, eyes etc are not da
product.
sk your safety by dismantling casings, covers etc that are screwed
tight.
sk your safety by setting safety equipment out of function.
ctric or the cooling system must be done only by a
qualified person.
adjusts the step sequence of the
EAT
he load circulation pump will be run without water and therefore
ver place yourself under the lifted up
n.