Kodak ESP 9 Start Here Manual page 6

5
Loading Paper and Calibrating
Paper
.
output tray
Bottom
.
paper tray
Bottom paper tray
extender tab
6
a) Raise the paper output tray and pull the bottom paper
tray out.
b) Load plain paper and slide the 2 paper edge guides
against the left and front edge of the paper.
c) Close the bottom paper tray.
NOTE: If the bottom paper tray will not close all the
way, press the bottom paper tray extender tab on the
front left edge of the tray while pushing the tray in.
d) Pull out the top paper tray and insert 4x6 in. (10x15 cm)
photo paper face down.
Slide the paper edge guides, close the top paper tray.
Lower the paper output tray.
e) Press START. Calibration will take 2-3 minutes.
OK
www.kodak.com/go/aiosupport