DeWalt D28715-XE Instruction Manual page 11

FIG. 10
Y
8 mm
(.3")
W
Lubrication
Closed-type, grease-sealed ball bearings are used throughout. These bearings have
sufficient lubrication packed in them at the factory to last the life of the chop saw.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once
a week. To minimize the risk of eye injury, always wear AS/NZS1337 approved eye
protection when performing this.
WARNING: Never use solvents or other harsh chemicals for cleaning the non-
metallic parts of the tool. These chemicals may weaken the plastic materials used in
these parts. Use a cloth dampened only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool into a liquid.
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should be performed by certified
service centers or other qualified service organizations, always using identical
replacement parts.
ACCESSORIES
WARNING: Since accessories, other than those offered by D
tested with this product, use of such accessories with this tool could be hazardous.
X
To reduce the risk of injury, only D
with this product.
Y Recommended accessories for use with your tool are available at extra cost from
your local service center. If you need any assistance in locating any accessory, please
contact Stanley Black & Decker, 82 Taryn Drive, Epping, VIC 3076 Australia or call
1800 444 224 or (NZ) 0800 339 258.
V
11
WALT, have not been
E
WALT recommended accessories should be used
E