Polluted air is drawn into the unit by the belt driven 230V, 60 HZ, 3 PH. 14.4 blower on the T5200 unit. After passing through a pre- filter, the particles in the air are given an electrical 460V, 60 HZ, 3 PH.
6. Screw a ½”-13 x 1-1/4” long eye bolt (or larger) in door is not closed securely. each hole. The T5200 unit is supplied with weld nuts at each dimple location. NOTE: The blower access door is not protected by an interlock switch.
A. All construction debris is removed from the ionizing- collecting cells, drain connections and ductwork. B. The drain line from the Trion drain basin is clear and completely connected to its point of termination.
Trion factory labor. damp. Turn the unit OFF and allow the cells to dry completely. Trion shall not be responsible for loss of use of any product, loss of time, inconvenience, or damage to other Inspections equipment or any other indirect or consequential...
VII. TROUBLESHOOTING GUIDE IF PROBLEM CANNOT BE DETERMINED OR CORRECTED - CONTACT YOUR LOCAL TRION REPRESENTATIVE OR CALL TRION CUSTOMER T5200 Problems and Possible Causes: SERVICE AT 1-800-884-0002 FOR ASSISTANCE. 1. High Voltage Indicating Light Out a. Power not connected WARNING b.
Need help?
Do you have a question about the Air Boss T5200 and is the answer not in the manual?
Questions and answers