Table of Contents
Advertisement
TG6411-6421NZ(e).book Page 38 Tuesday, March 31, 2009 1:07 PM
Useful Information
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
Display message
Cause/solution
L The supplied telephone line cord has not been
Check Phone Line
*1
L Recording was too short. Try again.
Error
L Phonebook copy failed (page 19). Confirm the other
Failed
L The receiver's phonebook memory is full. Erase the
Incomplete
L The phonebook memory is full. Erase unnecessary
Memory Full
L Message memory is full. Erase unnecessary
L The call barred list memory is full. Erase unnecessary
L The handset has lost communication with the base
No link.
Reconnect AC
adaptor.
L Unplug the base unit's AC adaptor to reset the unit.
L The handset's registration may have been cancelled.
L A wrong type of battery such as Alkaline or
Use rechargeable
battery.
L You must subscribe to a Caller ID service. Once you
You must first
subscribe to
Caller ID.
*1 KX-TG6421/KX-TG6422
38
connected yet or not connected properly. Check the
connections (page 10).
handset (the receiver) is in standby mode and try
again.
unnecessary phonebook entries from the other
handset (the receiver) and try again.
entries (page 18).
*1
messages (page 30).
*1
entries (page 23).
unit. Move closer to the base unit and try again.
Reconnect the adaptor and try again.
Re-register the handset (page 24).
Manganese was inserted. Use only the rechargeable
Ni-MH battery noted on page 4, 7.
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.
Advertisement
Table of Contents
