Advertisement
A. Light Bulb Replacement
WARNING: To reduce the risk of personal injury, turn off power
and allow lights to cool before proceeding.
Halogen Bulbs
To remove the bulb, turn it counterclockwise. If the light is difficult to
remove, it may be necessary to use the light bulb suction cup that
has been provided with this manual.
Replace the bulb with a PAR20 120 volt, 50 watt halogen bulb (Vent-
A-Hood
part number P1130).
®
Fluorescent Bulbs and Starter
Non-covered fixtures - To Remove the lamp, facing the hood, grasp
the bulb at each end and twist up and away. Take Care not to put
too much force on the glass as it may easily be broken.
Covered Fixtures - To remove the lamp, facing the hood, remove
the plastic cover, grasp the bulb at each end and twist down and
away. Take care not to put too much force on the glass as it may
easily be broken.
Replace the bulb with an 18 inch, 15 watt T8 fluorescent bulb (Vent-
A-Hood
part number P1120). Hold the new lamp at each end and
®
rotate it slowly into the sockets until it locks into position.
To remove the starter, turn the starter counterclockwise (when facing
the starter). Replace the starter with a FS-2 type starter (Vent-A-
Hood
part number P1105).
®
Maintenance/Troubleshooting
Page 5
L021
Advertisement
