Rear Body Components (Four-Passenger) - Club Car 2009-20011 Electric Precedent Maintenance And Service Manual

BODY AND TRIM
625

REAR BODY COMPONENTS (FOUR-PASSENGER)

Rear Beauty Panel Removal
1. Remove seat support. See Seat Support Removal on page 4-13.
2. Remove four screws (13) attaching the rear beauty panel (12) to the fuel bucket (Figure 4-8, Page 4-12).
3. Remove two screws (14) and remove the Forward/Reverse switch housing (15) from vehicle.
4. Disconnect electrical wires from the Forward/Reverse switch (16).
5. Lift rear beauty panel from vehicle.
Rear Beauty Panel Installation
1. Install rear beauty panel (12) on vehicle. Make sure body clips (17) on the rear of the beauty panel engage
the mating slot in the rear underbody. Secure beauty panel in place with four screws (13). Tighten screws to
3.7 ft-lb (5 N·m) (Figure 4-8, Page 4-12).
2. Connect the three wires to the Forward/Reverse switch (16) as shown.
3. Position the Forward/Reverse switch housing (15) on the front of beauty panel (12) and secure with two screws
(14). Tighten screws to 20 in-lb (2.3 N·m).
4. Install seat support. See Seat Support Installation on page 4-14.
Access Panel
Access panel (6) is secured to the rear underbody (4) with two push rivets (7) (Figure 4-8, Page 4-12). When replacing
the panel, insert push rivets (7) to hold the panel in place.
Rear Underbody Removal
1. Remove four screws (5) attaching the rear underbody (4) to vehicle (Figure 4-8, Page 4-12).
8
6
2
10
Figure 4-11 Foot Deck (Four-Passenger Vehicles)
2009-2011 Electric Precedent Maintenance and Service Manual
Rear Body – Four-Passenger Vehicles
7
4
11
3
4
1
Page 4-15