Club Car 2009-20011 Electric Precedent Maintenance And Service Manual page 376

21
Axle Bearing and Shaft
CAUTION
• Do not scar or damage the inside surfaces of the tube when removing the oil seal and adapter ring. A
damaged tube might have to be replaced.
NOTE: Do not discard the adapter ring. If the adapter ring is lost or damaged, the axle tube will have to be replaced.
Varying rear axle configurations have been installed on vehicles. If replacing axle tubes, take note of individual
axle tube lengths to ensure proper fit.
6.2. Use a press to separate the axle oil seal (15) from the adapter ring (39) (Figure 21-3, Page 21-2). Retain
the adapter ring and discard the oil seal.
7. Inspect the axle shaft assembly to be sure the bearing and collar have not slipped and are still seated against
the shoulder on the axle shaft.
8. Inspect bearing (5) (Figure 21-5, Page 21-3). If the bearing in a Type G transaxle is worn or damaged, the
entire axle shaft assembly (1 or 2) must be replaced.
2
762
Figure 21-1 Remove Internal Retaining Ring
A. Adapter Ring Lip
764
Figure 21-3 Axle Seal and Adapter Ring
Page 21-2 2009-2011 Electric Precedent Maintenance and Service Manual
1
763
A
39
15
765
Figure 21-2 Axle Seal and Adapter Ring Removal
Figure 21-4 Axle Seal and Adapter Ring Installation
TRANSAXLE (TYPE G)