Maintenance - Performax 240-3688 Operator's Manual

Crown molding has a high top rear spring
angle (the section that fits flat against the
ceiling) of 52° and a bottom rear spring angle
(the section that fits flat against the wall) of
38° .
key Miter Setting
IL 31 .6° Right
IL 31 .6° Left
IL 31 .6° Right
OR 31 .6° Right
WARNING:
reliability, all repairs should be performed
by a qualified service technician.
WARNING:
only identical replacement parts. The use
of any other parts may create a hazard or
cause damage to the product.
WARNING:
from the power source before cleaning or
performing any maintenance.
WARNING:
goggles or safety glasses with side
shields during power tool operations, or
when blowing dust. If operation is dusty,
also wear a dust mask.
OPERATION
bevel Setting Type of cut
33 .9°
33 .9°
33 .9°
33 .9°

MAINTENANCE

To ensure safety and
When servicing, use
Unplug the Miter saw
Always wear safety
Inside corner - Left side
1 . Position top of the molding against the fence .
2 . LEFT side is finished piece .
Inside corner - Left side
1 . Position bottom of the molding against the fence .
2 . LEFT side is finished piece .
Outside corner - Left side
1 . Position bottom of the molding against the fence .
2 . RIGHT side is finished piece .
Outside corner - Right side
1 . Position top of the molding against the fence .
2 . RIGHT side is finished piece .
Periodic maintenance allows for long life
and trouble-free operation . A cleaning,
lubrication
should be maintained . As a common
preventive maintenance practice, follow
these recommended steps:
1 . When work has been completed, clean
the tool to allow smooth functioning
of the tool over time .
2 . Use clean damp cloths to wipe the tool .
3 . Check the state of all electrical cables .
4 . Keep the motor air openings free of
oil, grease and sawdust or woodchips,
and store the tool in a dry place .
5 . Be certain that all moving parts are well
lubricated with silicone or light oil spray,
particularly after lengthy exposure to
damp and/or dirty conditions . Do not use
grease, because it tends to attract and
hold sawdust .
and maintenance schedule
Page 30