Adjustment; Program The Travel Limits - Chamberlain LiftMaster Elite Security+ 3800PLD Installation Manual

Adjustment

1

Program the Travel Limits

Travel limits regulate the points at which the door will stop when moving up or down.
Adjust the position of the door by using the black and purple buttons. Black moves the
door UP (open) and purple moves the door DOWN (close).
SETTING THE UP POSITION:
1
Press and hold the black button until the LED starts fl ashing slowly, then release.
2
Push and hold the black button until the door reaches the desired UP (open) position.
NOTE: Make sure the door opens high enough for your vehicle.
3
Push the door control or programmed remote control. This sets the UP (open) limit
and begins closing the door.
4
Immediately when the door begins to close, press and release either the black or
purple button. This will stop the door.
SETTING THE DOWN POSITION:
5
Push and hold the purple button until the door reaches the desired DOWN (closed)
position.
6
Once the door is closed, if there appears to be too much pressure on the door, you
may toggle the door back and forth using the black and purple buttons to reach the
desired closed position.
7 Push the door control or programmed remote control. This sets the DOWN (close)
limit and the door should open.
Proceed to Set the Force.
1
LED
4
or
2
5
19
Without a properly installed safety
reversal system, persons (particularly
small children) could be SERIOUSLY
INJURED or KILLED by a closing
garage door.
• NEVER learn forces or limits when
door is binding or sticking. Repair
door fi rst.
• Incorrect adjustment of garage door
travel limits will interfere with proper
operation of safety reversal system.
• After ANY adjustments are made,
the safety reversal system MUST
be tested. Door MUST reverse on
contact with 1-1/2" high (3.8 cm)
object (or 2x4 laid fl at) on fl oor.
To prevent damage to vehicles, be
sure fully open door provides adequate
clearance.
3
or
6 7
or