Resetting The Remote Memory; Reassigning Device Control - JBL AVR580 Owner's Manual

Before programming the remote for
•
Volume, Channel or Transport Punch-
Through, make certain that any pro-
gramming needed for the specific TV,
CD, DVD, cable or satellite receivers has
been completed.

Reassigning Device Control

Selectors
Although each Input Selector e is nor-
mally assigned to the category of product
shown on the remote, it is possible to
reassign one of these buttons to operate a
second device of another type. For exam-
ple, if you have two VCRs but no satellite
receiver, you may program the "SAT" but-
ton to operate a second VCR. Before fol-
lowing the normal programming steps for
either Three-Digit entry or Auto Search
code entry, you must first reassign the but-
ton with the following steps:
1. Press the Input Selector e you wish
to reassign and the Mute Button
at the same time until the red light
appears under the Input Selector e
and the Program/SPL Indicator c
flashes amber.
2. Press the Input Selector e for the
device you wish to program into the
reassigned button.
3. Enter the three-digit code for the spe-
cific model you wish the reassigned
button to operate.
4. Press the same Input Selector e
pressed in Step 1 once again to store
the selection. The red LED under the
reassigned Input Selector will flash
three times and then go out.
Example: To use the CBL/SAT button
to operate a second VCR, first press
the Video 2/CBL/SAT Input Selector
43
e and the Mute Button
same time until the red light glows
under the Video 2/CBL/SAT Button
e. Press the VCR Button e, fol-
lowed by the three-digit code for the
specific model you wish to control.
Finally, press the Video 2/CBL/SAT
Button e again.

Resetting the Remote Memory

As you add components to your home
theater system, occasionally you may wish
to totally reprogram the remote control
without the confusion of any commands,
macros or "Punch-Through" programming
that you may have done. To do this, it is
possible to reset the remote to the original
factory defaults and command codes by
following these steps. However, once the
remote is reset, all commands or codes
that you have entered will be erased and
will need to be reentered:
1. Press any of the Input Selector
Buttons e and the "O" Button r
at the same time until the Program/
SPL Indicator c begins to flash
amber.
2. Press the "3" Button r three times.
3. The red LED under the Input Selector
e will go out and the Program/SPL
43
Indicator c will stop flashing and
turn green.
4. The Program/SPL Indicator c
will remain green until the remote is
reset. Note that this may take a while,
depending on how many commands are
in the memory that need to be erased.
5. When the Program/SPL Indicator
c goes out, the remote has been
reset to the factory settings.
at the
45