Table of Contents
Advertisement
WALL-MOUNTING
Important Safety Note: The
customer is solely responsi-
ble for proper selection of
mounting hardware not
included with the speakers,
and for proper assembly and
installation of the wall-brack-
ets, including but not limited
to the selection of appropri-
ate weight-bearing supports
and proper use of the
bracket. JBL disclaims any
liability for the selection of
mounting hardware and/or
bracket installation. Be sure
to follow these bracket
assembly and installation
instructions carefully. If you
have any questions or
doubts about your ability to
correctly wall-mount the
speakers, consult with your
authorized JBL dealer or
custom installer.
Step 1: Unscrew and remove
the large Molded Nut
necessary, use the supplied
∞
Metal Bar
as a lever by
inserting it into one of the
holes in the outer edge of the
™
Molded Nut
.
Step 2: Firmly grasp the Ball
£
and Shaft
and pull it
straight out of the Attach-
¢
ment Plate
. Avoid leaning
it to the side for leverage, as
this may break off a tab.
4
3
8
5
Step 3: Slide the Molded Nut
™
onto the Ball and Shaft
£
with the threaded open-
ing facing the ball. Thread
the Metal Nut ¡ all the way
onto the Ball and Shaft £,
with the star washer side
away from the ball. Refer to
the exploded drawing for the
proper orientation of these
three parts.
™
. If
Step 4: Screw the Ball and
Shaft
Insert
Satellite Speaker
it is fully seated in the
Threaded Insert
not tighten as you might dis-
lodge the Threaded Insert
§. Such damage would
not be covered under the
warranty.
2
1
£
into the Threaded
§
on the back of the
¶
until
§
, but do
Step 5: Tighten the Metal Nut
¡
with the star washer side
between the Metal Nut
and the back of the Satellite
¶
Speaker
, using large
needle-nose pliers until it is
firmly seated against the
back of the Speaker
has locked the Ball and
£
Shaft
and the Speaker
together.
Note that once the Metal
¡
Nut
is fully tightened, it
may embed some marks on
the back of the Satellite
¶
Speaker
. However, these
marks will be covered by the
¡
Metal Nut
Step 6: Mount the Attach-
¢
ment Plate
stud on the wall, using four
#10 pan-head wood screws
at least one inch long (not
•
supplied)
.
7
6
1
2
3
5
8
Make sure that all four
screws are driven into the
stud and not into drywall.
If the bracket needs to be
mounted in drywall, the
customer is responsible for
selecting and using appro-
priate wall-anchors and
screws.
Important Note: The Metal
¡
Nut
must be fully tight-
ened against the Satellite
¡
¶
and
¶
.
into a wood
4
7
Hide quick links:
Advertisement
Table of Contents
