Wall Mounting - JBL SCS300.7 Owner's Manual

Gently pull the slack out of the
wire and screw the adaptor
onto the back of the speaker
in two places, as shown.
The floor stand adaptor
screws may be found in
Hardware Bag B. Use the
larger screw in the upper
screw hole, and the smaller
WALL-MOUNTING
4
8
Important Safety Note: The
customer is solely responsi-
ble for proper selection of
mounting hardware not
included with the speakers,
and for proper assembly and
installation of the wall-
brackets, including but not
limited to the selection of
appropriate weight-bearing
supports and proper use of
the bracket. JBL disclaims
any liability for the selection
of mounting hardware
and/or bracket installation.
Be sure to follow these
bracket assembly and instal-
lation instructions carefully.
If you have any questions or
doubts about your ability to
correctly wall-mount the
speakers, consult with your
authorized JBL dealer or
custom installer.
Step 1: Unscrew and remove
the large Molded Nut ™. If
necessary, use the supplied
Metal Bar ∞ as a lever by
6
screw in the lower screw hole.
Screw the floor stand adaptor
into the floor stand's threaded
insert until the speaker is
firmly attached to the stand.
Back off slightly from the fully-
tightened position until the
speaker is oriented as desired,
then rotate the thumbwheel at
3
2
5
inserting it into one of the
holes in the outer edge of
the Molded Nut ™.
Step 2: Firmly grasp the Ball
and Shaft £ and pull it
straight out of the Attach-
ment Plate ¢. Avoid leaning
it to the side for leverage, as
this may break off a tab.
Step 3: Slide the Molded Nut
™ onto the Ball and Shaft
£ with the threaded open-
ing facing the ball. Thread
the Metal Nut ¡ all the way
onto the Ball and Shaft £,
with the star washer side
away from the ball. Refer to
the exploded drawing for the
proper orientation of these
parts.
Step 4: Screw the Ball and
Shaft £ into the Threaded
Insert § on the back of the
Satellite Speaker ¶ until
it is fully seated in the
Threaded Insert §, but do
not tighten as you might
dislodge the Threaded
1
the bottom of the floor stand
adaptor to secure the speaker
to the stand.
7
6
1
2
3
5
8
Insert §. Such damage
would not be covered under
the warranty.
Step 5: Tighten the Metal
Nut ¡ with the star washer
side between the Metal Nut
¡ and the back of the
Satellite Speaker ¶, using
large needle-nose pliers,
until it is firmly seated
against the back of the
Speaker ¶ and has locked
the Ball and Shaft £ and
the Satellite Speaker ¶
together. Note that once the
Metal Nut ¡ is fully tight-
ened, it may embed some
marks on the back of the
Satellite Speaker ¶.
However, these marks
will be covered by the
Metal Nut ¡.
Step 6: Mount the Attach-
ment Plate ¢ into a wood
stud on the wall, using four
#10 pan-head wood screws
at least one inch long (not
supplied) •. Make sure that
all four screws are driven
4