2. Type system image fabric all <file_name> (where <file_name> is the name of the new fabric
card system image) to set the system image for all fabric cards.
3. Type system image line all <file_name> (where <file_name> is the name of the new line card
system image) to set the system image for all line cards.
7.1.4 Reload System
Finish the process by resetting the switch.
1. From File Mode, type exit to access Enable Mode.
2. Type reload to reset the switch without power cycling. This command terminates all network
connections and loads the settings from the startup-config file.
– 26 –