Table of Contents
Advertisement
3-2
3.0
RF Test Mode
When the radio is operating in its normal environment, the radio's microcontroller controls the RF
channel selection, transmitter key-up, and receiver muting. However, when the unit is on the bench
for testing, alignment, or repair, it is removed from its normal environment and cannot receive
commands from its system. Therefore, the internal microcontroller does not key the transmitter or
unmute the receiver. This prevents the use of a normal tuning procedure. To solve this problem, a
special "test mode" is incorporated into the radio.
To enter test mode (display radios):
1.
Turn the radio on.
2.
Within ten seconds after the self test is complete, press button P2, five times in succession.
3.
After "CSQ CHXX SP25" appears in the display, the radio is on channel XX, carrier squelch
mode, 25 kHz channel spacing.
4.
Each additional press of P2 scrolls through to the next channel spacing and a corresponding
set of tones are sounded.
5.
Pressing P1 scrolls through and accesses test environments as shown in 3-2.
6.
Pressing P2 for three seconds switches the radio to the control head test mode. 'LCD Test'
appears on the display.
7.
Pressing P1 causes the radio to turn on all the dots of the first character. Another P1 press
turns on all the dots of the next character and so on until the last character.
8.
Pressing P1 at the end of the LCD test activates the 'Icon Test'. The next P1 press turns on
the first icon.
9.
Pressing P1 at the end of the Icon test activates the "Button Test" mode. Pressing any button
(except P1) or any keypad button during the LCD test or Icon test immediately activates this
test.
10. Pressing P2 for 3 seconds in the control head test mode causes the radio to return to the RF
test mode.
RF Test Mode
Hide quick links:
Advertisement
Table of Contents
