Page 1
GM350 Mobile Radio Radio Service Software (RSS) Installation 68P02924X10B European Publications Department (RPG) Fleet, Hampshire, England Issue: October 1996...
Page 3
Table of Contents Chapter 1 RSS Installation Manual Table of Contents Paragraph Page Introduction ....................1 GM350 Mobile Radio Connection Information ........2 Configuring the RIB and GM350 Radio ........... 2 Installing the RSS ..................3 RSS Installation Manual...
Page 4
Table of Contents 1-ii RSS Installation Manual...
Introduction Introduction This chapter provides an overview of the GM350 Radio Service Software (RSS) and shows how to connect the radio to a computer and install the programming software. The user manual for the RSS is contained within the application and can be printed if required. The user manual is independant of the RSS screens and can be viewed at any time during programming.
Figure 1-1 GM350 Radio Programming Setup. Configuring the RIB and GM350 Radio Connect the RIB to the computer (Figure 1-1) using the interface cable 3080369B71 or 3080369B72 depending on the computer connection to Serial COM Port 1. If you are unsure of the connection on the back of your computer or the COM port, then please consult the computer manuals.
After all of the prompts have been answered, the RSS will be installed as specified. To run the RSS run the executable file. For example, GM350 <return>. To install the RSS into Microsoft Windows: Switch on the PC and then insert the RSS disk into A: drive.
Page 8
Installing the RSS RSS Installation Manual...