Dolby Pro Logic - JBL CSB5 Owner's Manual

CS OM 6/5/06 11:43 AM
DOLBY ® DIGITAL OR DTS
(OR OTHER DIGITAL SURROUND MODE) CONNECTION
RECEIVER
LINE
LFE OUT
LEVEL
IN
Use this installation method
for Dolby Digital, DTS or
other digital surround
processors:
Use the line-level input jack
marked "LFE" for the low-

DOLBY PRO LOGIC

Use this installation method
for Dolby Pro Logic applica-
tions (not Dolby Digital, DTS
or other digital processing),
where the receiver/proces-
sor is equipped with a sub-
woofer output, or a volume-
controlled preamp (line-)
level output:
Left Front
– +
– +
Left
Surround
Left Surround
– +
Page 7
®
frequency effects channel.
SUBWOOFER
Connect this jack to the LFE
L
output or subwoofer output
LFE
on your receiver or amplifier.
R
Connect each speaker to
the corresponding speaker
terminals on your receiver
or amplifier.
Make sure that you have
configured your surround
sound processor for "Sub-
woofer On." Also configure
® (NON-DIGITAL) – LINE LEVEL
Use RCA-type interconnects
to connect the line-level
subwoofer outputs on your
receiver or amplifier to the
line-level inputs on the sub-
woofer. IMPORTANT: Do not
use the LFE input on the sub-
woofer with Dolby Pro Logic
processors.
Center
– +
Subwoofer
Line
Level In
L
R
Receiver
Subwoofer
Left Right
Out
Front Front
– +
– + – +
R L
Center
– + – +
Surround Back Surround Back
Left Right
Surround Back Surround Back
– + – +
Left Right
your receiver for 5.1-, 6.1-
or 7.1-channel operation, as
appropriate. The front left,
front right, center and rear
speakers should all be set
to "Small." If your receiver
allows you to set the cross-
over frequency between the
subwoofer and the main
speakers, select 100Hz or
the setting that is the closest
frequency below it.
NOTE: If your receiver or
amplifier has only one sub-
woofer output jack, then you
will need to use a Y-connector
(not included). Plug the male
end of the Y-connector into
your receiver or amplifier's
subwoofer output jack, and
connect each of the two
female ends to separate
RCA-type interconnects.
Right Front
Finally, plug the RCA-type
– +
interconnects into the line-
level inputs on the sub-
woofer.
Connect each speaker to
the corresponding speaker
terminals on your receiver
or amplifier.
Make sure your receiver or
processor is correctly con-
figured to indicate that the
subwoofer is "On."
– +
Right
Surround
Right Surround
– +
7