Identification Of Controls; Front Panel - NAD M15 HD Owner's Manual

IDENTIFICATION OF CONTROLS

FRONT PANEL

1 2
1 STANDBY LED
• This indicator will light up amber when the M15 HD is at standby
mode.
• When the M15 HD is powered up from standby mode, this indicator
will illuminate blue.
• If a Zone (Zone 2, Zone 3 or Zone 4) is ON and STANDBY button
is pressed to switch the M15 HD to standby mode, the VFD will
be extinguished but the STANDBY LED remains illuminated blue.
This indicates a Zone (Zone 2, Zone 3 or Zone 4) is still active. The
corresponding active Zone icon(s) will also remain displayed in the
VFD.
• In order to completely shut down the M15 HD with Zone 2, Zone
3 and/or Zone 4 still ON, press and hold STANDBY button until the
STANDBY LED turns amber.
• In the unlikely event that the M15 HD switches to protection state,
this indicator will illuminate red.
• When infrared command from the HTRM is received, this indicator
will also flash momentarily.
2 STANDBY BUTTON
• Press this button to switch ON the M15 HD from standby mode. The
Standby LED indicator will turn from amber to blue and illuminate
the VFD. Pressing the STANDBY button again turns the unit back to
standby mode.
• The M15 HD can also be switched ON from standby mode by
pressing any of the front panel buttons.
NOTES
• The rear panel POWER switch must be in the ON position for the Standby
button to activate.
• If "Auto Trigger In" at Trigger Setup menu is assigned to "Main" or "All"
and the +12V TRIGGER IN switch is set to "AUTO" mode, the standby
button in the front panel as well as the corresponding ON/OFF function
keys in the HTRM remote control will be disabled effectively handling
this function to an external controller. Slide to "OFF" the +12V TRIGGER
IN switch to maintain normal power ON/OFF function procedures.
6
3 4
6 7 8 9
3 REMOTE SENSOR
• Point the HTRM remote control at the remote sensor and press the
• Do not expose the remote sensor of the M15 HD to a strong light
Distance: About 23ft (7m) from the front of the remote sensor.
Angle: About 30o in each direction of the front of the remote sensor.
4 VACUUM FLUORESCENT DISPLAY (VFD)
• Displays visual information about the current settings like the active
• Refer also to the item about DISPLAY SETUP under the USING THE
5 VOLUME
• Use this control to adjust the overall loudness of the signal output at
• The default volume level is -20dB.
• The VOLUME knob is also used to increment/decrement other
6 3 SOURCE 4
• Toggle through the input selections - Source 1, Source 2, Source 3,
• Refer also to the item about SOURCE SETUP under the USING THE
7 INFO
• Show information as supplied by the applicable source.
• Toggle [INFO] button to display supplied information.
10 11
buttons.
source such as direct sunlight or illumination. If you do so, you may
not be able to operate the M15 HD with the remote control.
Source, volume level, listening mode, audio format, iPod-related
display information and other related indicators.
M15 HD - SETUP MENU segment of the OPERATION section.
AUDIO PRE-OUT.
adjustable parameters like Tone Controls.
iPod, Source 5, Source 6, Source 7, Source 8 and Source 9.
M15 HD - SETUP MENU segment of the OPERATION section.
5