Daewoo KOR-6L153S Service Manual page 14

Microwave oven

Hide thumbs Also See for KOR-6L153S:

Table of Contents

6. To remove high voltage capacitor.

1) Remove the screw which secure the grounding ring

terminal of the H.V. diode and the capacitor holder.

2) Remove the H.V. diode from the capacitor holder.

3) Reverse the above steps for reassembly.

High voltage circuit wiring

7. To remove magnetron.

1) Remove two screws which secure the magnetron.

2) Remove the magnetron.

3) Reverse the above steps for reassembly.

NOTE : Never install the magnetron without the metallic gasket plate which is packed with each magnetron to pre-

vent microwave leakage. Whenever repair work is carried out on magnetron, check the microwave leakage. It shall

not exceed 4mW/cm

for a fully assembled oven with door normally closed.

Wave guide

Metallic gasket plate

Magnetron antenna

Table of Contents