Setting The Time Clocks; Setting The Mechanical Clock - Ariston C Operating Instructions Manual

6. Setting the Time Clock
6.1

Setting the Mechanical Clock

12
9
3
6
Fig. 4
A
1 1
C
I
B
Fig. 5
1. General layout
The mechanical clock covers a 24 hour period. Each tappet represents 15 minutes A (Fig. 5). An override switch is located on
the clock B (Fig 5).
2. To set the time
To set the time of day, grasp the outer edge of the dial and turn slowly clockwise until the correct time is lined up with the arrow
C (Fig. 5).
3. To Set the "On" and "Off" times
The clock uses a 24 hour system e.g. 8 = 8.00 am and 18 = 6.00 pm "ON" periods are set by sliding all tappets between the
"ON" time and the "OFF" time to the outer edge of the dial.The tappets remaining at the centre of the dial are the "OFF"
periods.
4. For operation
Set the selector switch B to the symbol to control the central heating by the clock. Set the selector switch B to «I» to select
permanent operation or to «0» to turn the central heating off permanently.
8