Troubleshooting; Please Do Not Return This Product To The Store - Bissell 6489 SERIES User Manual

T
roubleshooting
Vacuum cleaner won't run
Possible causes
1. Vacuum cleaner is not plugged in
2. Power button is not pressed down
Vacuum cleaner won't pick up or low suction
Possible causes
1. Tools, hose and/or extension wands are blocked
2. Filters are dirty
3. Dirt cup is full
4. Hose connector not securely attached to suction inlet
5. Crack or hole in hose
6. Air flow regulator is set to open or
minimum setting
7. Clog in the dirt cup
Visible dust escaping from vacuum
Possible causes
1. Dirt cup is full
2. Filters missing or installed incorrectly
3. Filters are dirty
4. Hose is blocked
5. Hose connector not securely attached to suction inlet
6. Crack or hole in hose
7. Dirt cup is open
Other maintenance or service not included in the manual should be
performed by an authorized service representative.
Thank you for selecting a BISSELL product.

Please do not return this product to the store.

For any questions or concerns, BISSELL is happy to be of
service. Contact us directly at 1-800-237-7691.
w w w . b i s s e l l . c o m
WARNING:
To reduce the risk of electric shock,
turn power OFF and disconnect plug
from electrical outlet before performing
maintenance or troubleshooting.
Remedies
1. Check electrical plug
2. Press power button down
Remedies
1. Remove each part and check for blockages
2. Check and clean or replace all filters
3. Empty dirt cup
4. Make sure hose connector is locked into
suction inlet
5. Check hose and replace if needed
6. Change to closed or maximum setting
7. Clear clog from dirt cup following
instructions on page 12
Remedies
1. Empty dirt cup
2. Check all filters for correct installation
3. Check and clean or replace all filters
4. Remove hose and check for blockages
5. Make sure hose connector is locked into
suction inlet
6. Check hose and replace if needed
7. Follow Emptying the dirt cup instructions step(s) (1-5)
on page 8
8 0 0 . 2 3 7 . 7 6 9 1
13