Makita HR5000 Instruction Manual page 6

Selecting action mode
Rotation with hammering:
For drilling in concrete, masonry,
etc.,
rotate the change lever to the posi-
tion.
Hammering only:
For chipping, scaling or demolition opera-
tions, rotate the change lever to the
?
posi-
tion.
CAUTION :
.Do
not rotate the change lever when the tool is running under load. The tool will be
damaged.
.To avoid rapid wear on the mode change mechanism, be sure that the change lever is
always positively located in one of the
two
action mode positions.
Switch action
Release the trigger to stop.
To start the tool, simply pull the trigger.
Trigger switch
CAUTION:
0
Before plugging in the tool, always check to see that the trigger switch actuates properly
0
Do
not tape,
t i e
or otherwise secure the trigger in the "ON" position.
and returns to the "OFF" position when released.
Chipping
-
Scaling
-
Demolition
Hold the tool firmly with both hands. Turn
the tool on and apply slight pressure on
the tool
so
that the tool will not bounce
around, uncontrolled. Pressing very hard
on the tool will not increase the efficiency.
6